Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 2911 routers that will be connected via fiber with an ethernet Gig handoff to each router. Each router will then be connected to local networks on a second ethernet interface on the router. I have always connected routers via serial connect...
Hello,We have an ASA 5510 version 8.3 (2) that we accept VPN users via a radius server. Is there a way to lock down a specific user that connects to the ASA as a SSL client or IPSEC VPN user? If the specific user were to connect to the ASA, we would ...
I am running the SSM-10 off of an ASA 5510. While using the IME application, no data shows up under any gadget and I get the meeesage "No Data available to display" at each gadget. The gadgets that are showing this are Top signatures, Top attackers, ...
Hello,I have a 2811 router with 2 - V2-4FX0 interfaces installed. I am looking for documentation or direction on how to set up the 8 ports to be used as analog dial in and dialout ports for PPP (incoming) and fax (outgoing). I have found next to no...
Hello,I have two identical ASA 5510's with SSM-10 IPS modules. One of the SSM-10 modules is licensed, one is not. Can I move the licensed module (currently installed in the secondary ASA) to the other ASA 5510 (Primary) without causing a problem?Tha...
Peter,This is a small network with less than 20 sites as part of the WAN. The number of routes would be less than 5 at this site, no redundant connections needed, and additions and disconnections are very infrequent. I would perfer to not use static ...
Peter,Thanks for the quick reply. What specific routing would need to be configured? Dynamic is the default on the routers. Are you implying any kind of static routes that need to be set up or rip, igrp, etc?Thanks
The 1760's have the default single FE port. If I were to add a FE WIC would that suffice for the 30MB Fiber connection? What about the different subnet?Thanks,TJG
We have no other Cisco series routers. Are you implying that the 1700 would not work in this scenerio? It we were to go with L3 switches would the traffic have to be bridged from site to site? We currently have different subnets at each site.Thanks,T...
