Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there any similar functionality supported on ASR9k? DESA is a very interesting idea and is currently supported on 7600 (https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/cether/configuration/15-s/ce-15-s-book/ce-dyn-ether-servact.html). More speci...
When using a pots modem the data are transformed from digital to analog in order to go through the copper wire and then from analog to digital again (when they reach the other end).Does the same happen with dsl modems too? If not, are the data in dig...
Will there be any differences in ping times in the following scenarios?1. PPPoA (ADSL-over-POTS USB modem)2. PPPoA (ADSL-over-POTS ETH modem)3. PPPoA (ADSL-over-ISDN USB modem)4. PPPoA (ADSL-over-ISDN ETH modem)5. PPPoE (ADSL-over-POTS USB modem)6. P...
The following is from a C2950-24:%SPANTREE_FAST-7-PORT_FWD_UPLINK: VLAN0032 FastEthernet0/24 moved to Forwarding (UplinkFast).And this is from a C2924-XL:%SPANTREE_FAST-6-PORT_FWD_UPLINK: Port FastEthernet0/24 in vlan 9 moved to Forwarding (UplinkFas...
Hashing updates- Starting release 6.4.2, when an layer 2 interface (EFP) receives mpls encapped ip packets, the hashing algorithm if configured for src-dest-ip will pick up ip from ingress packet to create a hash. Before 6.4.2 the Hash would be based...
I currently have the following config (5.3.4 SP4) which is working fine:dhcp ipv4
vrf VRF-COMMON proxy profile IPOE-DHCP-PROFILE-1
profile IPOE-DHCP-PROFILE-1 proxy
helper-address vrf VRF-COMMON 10.1.0.2 giaddr 10.195.1.1
helper-address vrf VRF...
Hi,
I'm trying to figure out the outgoing interface (multiple outgoing interfaces using ECMP) for a PW but i'm a little bit confused:
RP/0/RSP0/CPU0:asr9k#sh l2vpn bridge-domain pw-id 3507030501 det
Legend: pp = Partially Programmed.
Bridge group: ...
I'm reading the following: > On ASR 9000 BFD instance may only run on a line card CPU. User must manually designate the line card CPU on which the BFD session will run. If> multiple line card CPUs are designated, multi-hop BFD sessions will be load-b...
