Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a 4500 that has a vlan (10) on it that none of the clients should talk to each other. I am going to configure this as a isolated vlan. This VLAN is propagated to a 6500 that has the IP address of this VLAN, from what I have read I need to cr...
HiHas anyone sucessuflly completed a downgrade of FWSM software for an active/standby set-up?I've been looking for a doc on Cisco.com and can't seem to find anything for downgrading, only this for upgrading..http://www.cisco.com/en/US/docs/security/f...
HiI have the following setupInternet connection --- router --- pix --- internal networkThe router - pix is on 10.10.10.0 and the internal network is 172.16.1.0, pix ip outside 10.10.10.75 internal 172.16.1.1.I have set-up my PIX so that this accepts ...
Mate - you can run this fine (I have one at home ).Sounds like your failover is activing like the failover unit - you need to make this the primary, can you enter "failover" in global config, this will then make the unit the primary and this will w...
