Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I in the process of migrating from ios slb to css11501 and would like to know if:Servers required to be configured with loopback addresses(as with IOS SLB) ? What would be the effect of leaving the Loopbacks on the Server'sThanks in advance for yo...
Hi All,Having problems with Server-to-Server connections through a CSS11501. Servers are on the inside, and connect through vip address. would this a valid configuration ? would appreciate any suggestion.Thx in advance.
Hiyou can use CNA to monitor bandwidth being utilized on the aggregating links over a few days.http://www.cisco.com/go/networkassistant/From the data gathered you should be able to determine your minimal BW required for the users.Rgdsnyr
Hi in addition, if enabled on an GW it would allow gatewayless machine's connect to remote machines;i.e with proxy-arp enabled on RouterA, PC1 will be able to connect to PC2 without GW configured on PC1.PC1 ====== Router A ========== Router B ====== ...
Hi L3 only between core,to ensure stability you might need to have all redundant devices (top/down) in active/standby mode.having them in active/active mode could lead to packet loss during single link failure within your network.rgdsnyr
