Has anyone seen the following output showing that the duplex is UNKNOWN, the far end says that the duplex is full. Is this an issue? What can cause this?I tried to set the duplex but there is only a speed command.CORE#show int g5/1GigabitEthernet5/1 ...
I have a client who cannot remember thier password for Cisco works and was wondering if there is a password recovery procedure or do i need to open a TAC case?Thanks in advance
Hi,I noted the following on one of the modules in a cisco 5000, the question is are all the vlans allowed or is only one vlan allowed accross the ports:set vlan 1 2/1-8,2/10-12set vlan 104 2/9set trunk 2/1 on isl 1-1005set trunk 2/2 on isl 1-10...
Thanks for the reply Jay, i have been looking through the forums and have found that kazaa2 uses different ports than 1214. The recommendation is to use NBAR to block the traffic. If there is anyone who can supply a config to use NBAR on a internet r...
Thanks for the reply,The software is as follows:4507:IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-IS-M), Version 12.1(14)E1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)The 4500 is connected to a 3550:IOS (tm) C3550 Software (C3550-I5Q3L2-M), Versio...
I am using a Pix firewall, i have four users who will be assigned a vpn group to each one:ip local pool vpnpool03 172.16.1.3ip local pool vpnpool02 172.16.1.2ip local pool vpnpool04 172.16.1.4ip local pool vpnpool01 172.16.1.1crypto ipsec transform-s...
Thank you for the post,I would appreciate it if you could point me to the sourse of information as i need to document it and supply to my client. Thanks again.