Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
We have configured OTV and believe we have it working between 2 DC's over a point to point routed WAN link. Each DC has a pair of Nexus 7004's using vPC for resilience for down linked equipment. A separate VDC has been created as per the Cisc...
Hi All,We are migrating our existing RIPv2 network to an external WAN setup using EIGRP/BGP. ISP is running BGP and we have configured mutual redistribution - all working perfectly well.For the legacy network we've redistributed RIP into EIGRP on a '...
Hi All,I have a requirement on our wireless network to ONLY approve authentication from machines that are pre-approved. We have our wireless network setup and it's all working well using RADIUS to Microsoft AD servers on the ACS for end user/machine ...
Hi All,I currently have a pair of Cisco 878's in a back-to-back configuration running absoultely fine with a line rate of approx 4Mbps. The 4-wire (EPS-8 baseband) circuit is provided by BT.The ever increasing need for speed has sent me towards inves...
Hi All,I'm sure this question has already been asked and the solution is simple - however it does not appear to be obvious!My requirement is to have an AD group called 'CiscoAdmins' and another called 'VPNUsers'. Using ACS I want to only authorise me...
Thanks for the replies and apologies for the delay in responding, been out of the office for a few days.I've switched off the auto-summarisation to no avail and have uploaded the debug IP rip output from both routers. In searching through the output ...
Hi Giuseppe,Thanks for the reply.I should have mentioned in my post but obviously neglected to...I've tried both fixed rates (as low as 1.5Mb!) and also leaving them to auto-train, (bearing in mind that the 878's synch on the same circuit at 4Mb 'fix...
Hi JK,So If I configured my AD as a 'Generic LDAP' rather than a 'Windows Database' it would make the configuration simpler?Happy to do so if this is the case (likewise with choice between TACACS or RADIUS)... I'm looking for the simplest configurati...
Thanks again JK,I'll give this a go and feedback ..So just to confirm, am I right in understanding that there is NO way of restricting access simply by checking AD group membership? Therefore the only way is to restrict certain elements as you descri...
Hi JG,I've already seen that paper - and although descriptive am still none the wiser as it does not give any example. What property do I check against? as there is no AD group membership property ..You HAVE however confirmed my thougts that a NAR is...
