jgervia_2

3G TestingFor this testing, AnyConnect 2.4.4009 was useddefault-domain: abc.comsplit-tunnel-list: 10...

Hello, The problem is that in the 6.x version of code it only recognizes the first 8 megs of flash. ...

also check your netmask - unless you're on the 10.0.0.0/24 network, you should make that netmask 255...

Please post the error message and configuration so we can help determine what's going on.

Hello, Unfortunately, once you have PDM installed, theres no way to delete/uninstall it so you don't...

Chris, I would check to see if there is crashdump present doing a 'show crash'. If there is, I'd ope...

Hello, I haven't done too much ABR work with the ASA - but it appears to have summarization (area ra...

Hello, I can't really tell what your question is, but the pix doesn't need to run a routing protocol...

Hello, You're probably running into the old ' you can't transit the firewall and ping an interface' ...

Hello, The following is listed for the the CCIE Security lab:http://www.cisco.com/web/learning/le3/c...

nameif ethernet4.1vlan 40nameif ethernet 4.2vlan 50etc. etc.You'll still need all the other nameif/i...

Hello, Trying to understand what you want to do here. You want to route a single IP address through ...

Not sure if this will work, try this(this assumes global_policy exists)class-map telnet match port t...