About cbeswick

cbeswick · 10-07-2014

Hi, Is it possible to use the native 40GE ports on the N7K-M206FQ-23L module for the VPC Peer Link, or do you have to break these ports out into 10GE ? I have read that 10GE ports must be used for the VPC peer link. Thanks in advance.

cbeswick · 06-26-2014

Hi,We are thinking of using manual CTS encryption on either natively routed ports, or Vlans / SVIs (Nexus 7ks) to form OSPF adjacencies, but need to understand if this will work across a providers QinQ network. It is my understanding that Trustsec e...

cbeswick · 03-11-2014

Dear All,Has anyone had any experience using the new "Trust Communication" feature in ACS 5.5 ?I am wanting to know if this will work with self signed certs, or even a public wildcard cert, i.e. *.domain.comI have tried exporting the self signed cert...

cbeswick · 11-27-2013

Hi,I am currently trialing ACS 5.5. I have two ACS instances which I want to configure as a primary / secondary but whenever I try to register the secondary node to the primary, I get the following message:"This System Failure occured: Registration f...

cbeswick · 10-10-2013

Hi,I need to configure tacacs to communicate with ACS 5.4 over the "FastEthernet 0" port on a Cisco 3560X. Is this possible using the"ip tacacs source-interface FastEthernet0" command ?All other IP Interfaces are public facing and we need to get AAA ...

cbeswick · 09-10-2014

Hi Derek, I have been unable to get trust communication working with self signed certs. If you are unable to use an approved third party to sign your root CA, then try openssl - this worked well for me. Chris.

cbeswick · 03-13-2014

Hi Jatin, Many thanks for your response.Yes, I have exported the self signed cert and private key from the primary, and imported onto the secondary, and visa versa. When I try and register the secondary to the primary I get an error message saying "i...

cbeswick · 11-28-2013

Brilliant! I didn't spot that, worked a treat, many many thanks!Chris.

cbeswick · 10-10-2013

Many thanks RIchard.

cbeswick · 10-10-2013

Hi Richard,Many thanks for your reply.The Fa0 interface will be configured with its own IP Address.Do you happen to know if static routes be configured to point to a next hop via this Fa0 interface with the ipbase image ?Chris.

Member Since	‎09-19-2004 03:32 AM
Date Last Visited	‎06-27-2018 12:18 AM
Posts	267
Total Helpful Votes Received	16

User Statistics

User Activity

Using 40GE ports for VPC Peer Link

Cisco Trustsec across QinQ provider network

ACS 5.5 Trust Communication

Problems with ACS 5.5 Trial and Primary / Secondary node registration

Help Needed - 3560X Tacacs Configuration

Hi Derek, I have been unable

Hi Jatin, Many thanks for

Problems with ACS 5.5 Trial and Primary / Secondary node registr

Help Needed - 3560X Tacacs Configuration

Help Needed - 3560X Tacacs Configuration