Please check the link below: http://www.cisco.com/en/US/products/hw/switches/ps628/prod_configuration_examples_list.html It has all you need to start working with your new switch Franco
... View more
Switch A fas0/0------trunk ------ fas0/0 Switch B ---------computer A |----------Computer B Vlans X, Y and Z in both switches fas0/0 sw trun en dot sw mo trunk sw trunk allo vlan X Y Z 802.1Q has the concept of Native VLAN, untagged traffic received in any port will be assumed to be part of it. Once the traffic reaches Switch B, the tag will be removed and the it will be forwarded through the interfaces that belong to specific vlans
... View more
After the upgrade, you can ask check the "show license all" output to see what licenses are available.
If the proper license is not there, they can enable "right to use" license in IOS.
... View more
Check this out: Unable to access a Catalyst switch with the web-based device manager or web interface utility https://www.ciscotaccc.com/kaidara-advisor/lanswitching/showcase?case=K51046141 Franco
... View more
Please check the following document: https://www.ciscotaccc.com/kaidara-advisor/lanswitching/showcase?case=K88041014 Links might be old so check this one out: This chapter describes how to configure EtherChannels on the Catalyst 6500 series switch Layer 2 or Layer 3 LAN ports. http://www.cisco.com/en/US/partner/docs/switches/lan/catalyst6500/ios/12.1E/native/configuration/guide/channel.html Regards, Franco
... View more
Secure HTTP is not supported on the 2950 http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_22_ea11/release/notes/OL14991.html#wp1002420 The following link might be helpful: https://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_22_ea11x/configuration/guide/swauthen.html#wp1237299 Regards, Franco
... View more
Have you tried to create a manual binding for one of the computers (Windows if possible) using the client-identifier instead of the hardware address option? Router(config)# ip dhcp pool Router(dhcp-config)# host [mask | /prefix-length] Router(dhcp-config)# client-identifier Router(dhcp-config)# client-name Here is an example (you will need to create one "pool" per computer): Router(config)# ip dhcp pool PC-1 Router(dhcp-config)# host 192.168.1.5 mask 255.255.255.0 Router(dhcp-config)# client-identifier 01c2.070e.b000.66 --- > please notice that you need to include "01" and change the "." as showed on the example. Router(dhcp-config)# client-name Where "c207.0eb0.0000" is the MAC address of the PC. Microsoft DHCP clients require client identifiers instead of hardware addresses. The client identifier is formed by concatenating the media type and the MAC address. For example, the Microsoft client identifier for Ethernet address b708.1388.f166 is 01b7.0813.88f1.66, where 01 represents the Ethernet media type. For a list of media type codes, refer to the "Address Resolution Protocol Parameters" section of RFC 1700, Assigned Numbers. To specify the hardware address of a Dynamic Host Configuration Protocol (DHCP) client, use the hardware-address DHCP pool configuration command. It is valid for manual bindings only. Regards, Franco
... View more
