Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
The reason posting this discussion to get rough idea how to migrate or replace old Cisco 7206VXR (NPE-G2) with ASR1002 or ASR1001. Currently my company have two Cisco 7206VXR (NPE-G2) router with the internet connection 500mbps and 1gbps running...
Just want to ask the feedback. Currently I have two Cisco 7200 series router running at our datacenter. Router specs as below
3 FastEthernet interfaces
3 Gigabit Ethernet interfaces
2045K bytes of NVRAM.
250880K bytes of ATA PCMCIA card at slot 2 (...
Hi,
My company currently deploy VOIP phone system in our new office. VOIP quality seem like very low and not able to hear the sound clearly. I'm pretty much sure we have to implement QoS to give higher priority to VOIP compare to web browsing. Can a...
Hi All
Currently I'm trying to establish site to site vpn connection between my two asa (9.1). I tried to run site to site vpn wizard and upon setup completed I do not see any active VPN session on monitoring windows.. I do not see any session on my...
Hi,
I just bough a new Cisco 1921 router to replace with my old Cisco 3660 router. Can any one let me know Cisco 1921 router capable to replace Cisco 3600 router or not? I tried to replaced with 1921, but some how my office internet was down after r...
Hi Palani
I'm a bit unclear this part:
With no features configured, you can expect 500Mbps (NPE-G1) and 1Gbps (NPE-G2). Reference doc is here. What this document does not (explicitly) say is that when max rated pkts are being pushed, CPU will be at ...
Bandwidth for
Router A: 500 Mbps
Router B: 1000 Mbps
Attached is router A and B bandwidth utilization.
Also attached is router cpu utilization for router A and B.
