Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,
We have a Cisco 4321 IOS-XR that we need to install a NIM-2GE-CU-SFP. We currently have this image installed as of now.
isr4300-universalk9.03.13.04.S.154-3.S4-ext.SPA.bin
Will the above version support the module in italics above?
Let me know,...
All,Is there a way to limit a certain AP to one individual SSID? We have a 2100 WLC and 6 AP's attached. Let me know if you need anymore information.Thanks.
All,I have an issue. Hub Rtr --> Edge Rtr Point to Point Subs Frame Relay. Every 4 minutes the host sends two Multicast packets. First one is very small and the second trails by spilt seconds and is not much larger. Issue, I debug and can see the...
What would be the best way to configure OSPF Routing to pass from R1 thru Checkpoint FW to R2 without establishing a GRE Tunnel. I have attmepted this via ethernet interfaces configured with "ip ospf network non-broadcast" command. Specifying neigb...
I have multiple subinterfaces (56K) on a single T1. We are implementing frame-relay traffic shaping and we have a CIR 28K. My Question, When applying the service policy to the frame-relay map I get the following error " requested bandwidth 8 (kbps)...
Thank You "hritter" I appreciate the insight with our problem. What is the best way to route through a firewall with a Cisco router on each side.Thank You
I have it resolved now. The MinCIR is set to half of the CIR and this created all the problems. I changed our MinCIR to be something under the CIR and all is working good now.Thansk,
