About ratatosk_2

ratatosk_2 · 04-07-2017

Desired result: allow Internet for all devices on subnet 10.32.54.128/28. Block access to all other internal networks using addreses from 10.0.0.0/8. Hosts on network must reach resources on 172.18.24.0/24. ACL is on VLAN (BVI) Interface, VLAN3 ingre...

ratatosk_2 · 03-04-2011

Hi! I'm trying to create a group of devices based on the IOS version that they are running to then create a software distribution job to those devices. I went to Admin | Group Management | Device and created a new User Defined Group. In the rule expr...

ratatosk_2 · 04-23-2008

I have a huge difference between discovered and collected devices in CM (422/275). It turns out that most of the difference consists of our ATA186 boxes showing up as discovered devices but not collected since they are not on a VLAN accesible to CM. ...

ratatosk_2 · 04-23-2008

Another thread here solved a lot of my out-of-sync problems (thanks!) but I have a few devices still giving me a headache. Removing and re-adding them to RME doesn't help, I still get 2 kinds of problems with my 3020 blade switches. "Startup config n...

ratatosk_2 · 04-18-2017

Thank you all for your solution suggestions but I found the solution in another ACL employed by my company. The missing statement is: permit tcp any any established.

ratatosk_2 · 04-10-2017

I am going to try the above tomorrow, I spent the day setting up a lab for this. It seems that ipbasek9 does not support vlan access maps and I suppose setting the ACL on the GigE-IF to the ISP router could do the trick if I define the source network...

ratatosk_2 · 04-08-2017

Also, if I add 35 permit ip any 172.18.24.0 0.0.0.255 then it works.

ratatosk_2 · 04-08-2017

Ok, but I have only ACL inbound (from VLAN) and no ACL at all on the traffic to the VLAN, since there is no ACL the return traffic should be able to flow without creating and ACL for return traffic, no? The message I get in the logs are from the IN A...

ratatosk_2 · 04-08-2017

I will check that on Monday when I am back in the office. I will make a quick Visio of the setup and attach shortly so everyone can be clear on the exact setup.

Member Since	‎04-23-2008 12:38 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	24

User Statistics

User Activity

vACL - Allow all but 2 networks does not work

Group Management Rule Expressions Q

Device discovery/data collection & ATA186

RME 4.1.0 and 3020 out-of-sync problem

Thank you all for your

I am going to try the above

Also, if I add

Ok, but I have only ACL

I will check that on Monday