Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I've tried to established tunnels between PE and wondering how should I apply the QoS. The physical connection for example goes like this:PE -> P -> P -> PEThe tunnels was from between the both PE, so would it be feasible to check in qos on the P...
Hi, recently been spending quite some times on figuring out a solution that can meet customer's requirement and ease the configuration maintenance in the future.Requirement:1. Must have @ least link or node protection aka FRR (so that put LDP signall...
Hi, since I'm exploring the possibilities of setting up an automesh tunnels, I re-use one of the scenario I found in CCIE SP practise lab and enable automesh configuration.Sad to say that the tunnel was created between 2 PE routers but it was not up,...
Hi, I've a customer with 4 primary sites (each primary site has 1 pair of P-routers), then we've 10 remote sites (each remote site has 1 pair of PE routers).So that makes up to 8 P-Routers and 20 PE-Routers. Things get messy here, we've got a request...
Hi, I'm having a scenarios for applying QoS on the entire customer network. Its something like this:i. Equipment -> Layer2 SW -> PE VRF -> PThe equipment's traffics are not marked with anything at least, the equipment gateway would be the PE VRF. I'm...
I've tried to building a proper physically full-meshed P router and has PE connected into the P cloud.With AutoTunnel primary and backup it works flawlessly, then I introduce a manual tunnels which configured to route particular type of traffics over...
But I really thought that your comments in the threads helps a lot.I'm thinking AutoTunnel Primary and Backup for most of the traffics, while a small portion of selected traffic via the Manual provisioned tunnel with explicit path.But I just had issu...
Here's both PE config attached, notice that the R3 has all the auto-tunnel up and with FRR running fine, and that's not the case with R4.If i delete both "int tunnel 1 and 2", both R3 and R4 will have total of 4 auto-tunnels up and with FRR enabled.A...
Hi Giuseppe,Thanks for the reply, if that's the case, I'd need to create 4 tunnels per direction, so as follows:1. tunnels for specific traffic2. protection tunnel for specific traffic3. tunnels for default traffic4. protection tunnel for default tra...
Hi Giuseppe,I've read some documents about the CBTS, and it stated it'll work in conjunction with non-TE path, and in my case, are those LDP signalled LSP.So I'll have specific tunnels created manually among sites and only match EXP5 and EXP6 for exa...
