Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Recently one of our Cat 6509 started giving the below mentioned error message and eventually crashed."No memory availale for asychronous request"Could some one throw some light and I am happy to give any additional info. on this.Thanks in advanc...
Hi All, We have two isp plugged into the same router. Lets say A and B. In the current setup we have X.X.X.124/24 to X.X.X.128/24 published to both the ISPs but with AS prepended to ISP B using route-map. For some reason we see some of the Tier-1 ISP...
Hi,Some of our sites are under constant attack with TCP Syn/Ack i.e Syn followed by an Ack and no Get HTTP. Would want the Firewall to hold the traffic until there is a geniune payload. Plz Help.Here is the sequenceAttacker sends SYNServer sends SYN/...
Hi, We are trying to Install a new IPS module into our exisiting Cisco ASA and we are getting Unresponsive Module not suppportedPlease have a look at the sh ver and sh module in the attachment
Hi, We have a VPN tunnel setup on the above mentioned router to one of our partners. Here is the SetupPartner VPN Router 7.7.7.2 <--> Internet <--> (6.6.6.6) Internet Router (10.1.1.1) <--> (10.1.1.2) VPN Router(6.6.6.2).The VPN router has 2 interfa...
Hi All,What is the best practise when it comes to placing the IPS is it before or after the Firewall (i.e before < Internet - IPS - Firewal - LANl > and after . Please through some of your thoughts and if possible with some explanation.Thanks in ad...
Hi,I would like to send aggregate and the X.X.128.0/24 only to ISP B. So can i have the final config asroute-map ril deny 10match ip address prefix-list network-allbut1route-map ril permit 20match ip address prefix-list network-aggregateroute-map ril...
Hi Giuseppe, You are right. I wanted to mask the original IP address and I ended up typing all wrong.Actually it should have beenx.x.124.0/24 to x.x.128.0/24If this is the case then the config i posted should be alright i guess."as Edison has noted...
