Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a WAP321 installed on a wall bracket inside a closet. I appears to have a HW failure and I am trying to remove it from it from the wall bracket. It is locked to the bracket, and I can't move it in any direction to pull it out of the bracket. I...
I have 4 Cisco WAP321 access points, connected to a Cisco SG200-26P switch, operating in PoE mode.3 of the APs are fine, but I am having a problem with one of the APs, which appeared to be working OK, but the other day when I unplugged the Ethernet c...
I have the most recent firmware 1.0.3.16, and I am seeing the same problem. Tons of "Fail to delete IPv4 ARP entry" in the emergency category of logs.
Does anyone know of a fix?
Hi xact1,Have you been able to solve this issue?I am having exactly the same issue with WAP321 connected to a PoE switch. It was working before, but when I unplugged the Ethernet cable and plugged it back again, it stopped working. When I connect the...
