Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts , i have just created my home lab for cisco ISE wired 802.1x , initially i am testing "open" mode , i have the following components Cisco ISE VM running 3.3 and patch 11cisco 3750X running IOS 15.4windows server 2025 configuring for AD...
on my Cisco ISE which is on version 3.3 , patch 7 i keep getting COA failed error messages as below5417 Dynamic Authorization failedthese messages pop for clients connecting to Guest and 802.1x based ssid's , i have updated COA key on my wireless 980...
Hello Experts i need to provision the 9800 controllers in my customer's network . i have defined all the configuration in dna center , there is an option for anchor groups where we can configure anchor controller IP addresses and priority. currentl...
i have the below setup in the lab foreign and anchor (both 9800) connected to the same L3 switch, mobility tunnel built and is UP (remote site but same country)the L3 switch connects to the Prisma SDWAN device (WAN)prisma wan device hosts the Guest s...
hello experts ,we are using 9120AXE-E , the E regulatory domain which is for Europe and middle east. in Qatar although the UNII 3 channels are allowed i am not able to select them in the 5 GHz profile. the issue is we are facing DFS issues and we ...
here are some outputs lab-switch#test aaa group ISE test-user password new-codeUser rejected lab-switch#test aaa group ISE test-user password legacyAttempting authentication test to server-group ISE using radiusUser authentication request was rejecte...
thanks for the valuable feedback , the wired autoconfig is set to automatic on the windows 10 machine , under authentication settings , PEAP is there with validate server cert option checked . the machine is AD joined and has the Root CA cert from ...
thanks for the reply , i did run the above commands on the switch , on the ISE side i could see user rejected , but it also mentioned -PAP is not enabled . i will post all the outputs as you requested soon.
