Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have SG350X switches and I'm experiencing pretty slow ssh connectivity when using it for management - console port with 9600b is probably much faster then what I see when using SSH
Another issue is when I try to copy'n'paste configuration when ...
Hello,
I'm trying to connect Cisco 2950 to 3550 and configure trunking but my Fa interfaces do not get up at all. I have tried cross-over cable and straight cable as well however I do not see any link on those ports. I have even tried to connect othe...
I'm testing upgrade of one of the older boxes with 8.4(7) to 9.1(7) and I'm trying to fix overlapping address range on multiple interfaces.
I have one public IP range assigned to outside interface and I have split this range into two separate VLANs a...
Hello,
I'm trying to setup static NAT for inbound RDP traffic to several servers on the inside network but I have troubles to make it work.
My configuration is like:
interface Gi0/0
nameif Internet
security-level 10
ip address 192.168.1.2 255.255.2...
OK it seems that the freezing is related to copy from some of the editors so there is something happening during the transfer of clipboard, interestingly ASA55xx or 3560 or 2950 devices do not have any problem when copy/paste basically same config (t...
I have tested another 3550 and 2950 switch and basically ended up at the same state. Interesting was that when I connected both switches for the first time I got link on both ends but then the 2950 switch did sort of "reset"?! (all diods got light up...
This configuration works fine on 8.4. It is configuration inherited / migrated over the years starting on some 7.x. Of course the NAT rules have been overwritten in the past during migration from 8.2 to 8.4.
They need less IPs in DMZ2 zone thats why ...
