About Basic-Fit

Basic-Fit · 01-06-2015

Hi, I'm trying to setup an SG300-10 switch to route traffic between two VLAN's, but I don't get it to work properly. Here's my setup with which I'm testing this: Layer 3 mode is enabledThe switch has two VLANs:VLAN 30 has IP address 10.30.250.21, ma...

Basic-Fit · 01-08-2015

While building a new test setup to do packet captures, suddenly it worked. I don't know what I've done different this time, but my problem's solved now. Thanks for you effort. Leo.

Basic-Fit · 01-07-2015

Hi Aleksandra, If it's ICMP related, that would mean that I should be able to use other protocols, but I'm not able to use SMB, HTTP and RDP either. ARP is layer 2 only, so I don't think it's ARP related either. There must be something in the switch ...

Basic-Fit · 01-06-2015

Hi,It's not related to the Windows firewall. It is disabled by a GPO on our network and I can ping both hosts if I connect them to the same VLAN.Regards, Leo.

Member Since	‎01-06-2015 03:28 AM
Date Last Visited	‎05-18-2018 05:01 AM
Posts	4

User Statistics

User Activity

SG300-10 - No routing between VLANs

While building a new test

Hi Aleksandra, If it's ICMP

Hi,It's not related to the