About Machi Ma

Machi Ma · 10-22-2017

Hello, I have created a access-list rules which using to bypass VPN-like traffic to SFR. And I would like to do summaries of them at syslog. Could you please advise how can I process it? There are various of access-list group and I just want ...

Machi Ma · 06-26-2017

Hello, I would like to like what is the LACP hash algorithm type support at ASA? I am looking for Layer 3 + 4 Also, is it have paramters to setup rate fast feature, miimon etc? Currently my ASA running version is 9.6(2) Thanks in advance

Machi Ma · 05-10-2017

Hello, I am studying PBR now. With example like http://www.cisco.com/c/en/us/support/docs/security/web-security-appliance/118156-configure-wsa-00.htmlcopy and rewrite part of config---------- vlan ip address ------------interface Vlan10desc User VLA...

Machi Ma · 04-25-2017

Hello, Currently I am working on MSTP config. While check existing config it looks like my active VLAN is running under instance 1 (MST01). However, my peer switch is running instance 0. Q. First question is does it I should change back to inst...

Machi Ma · 02-05-2017

Hello, Could you please advise what is meaning of negative current connection value when run 'show service-policy' Like below ---- Class-map: Incoming Set connection policy: per-client-max 2000 current embryonic conns 1801, current conn...

Machi Ma · 10-24-2017

Hello, Only I have following part: ============================== logging enablelogging timestamplogging trap warningslogging asdm informationallogging host management 192.168.0.211logging class auth trap informationalno logging message 106015no lo...

Machi Ma · 05-11-2017

Hello, The switch itself can be as a L3 switch. And I think need enable "ip routing" as well? so what should be correct config for PBR? ---------------------------------------------------------- ! ip routing ! interface Vlan10ip address 10.1.1.1 2...

Machi Ma · 02-05-2017

Thanks. I also find some related discussion regarding this bug. However it looks still did not fixed ? as I using 9.6(2) already

Machi Ma · 01-03-2017

Hi, I would like to shun the IP once is over the limit of bandwidth. Which I looking for. Is it able to do it? Thanks!

Machi Ma · 12-26-2016

Hello, I saw the max incoming traffic is around 29,000 pkts/sec which I think is reach to limit of 30,000 by spec show. However, is it CPU really high impact when over or near to limit it can handle? Anything I can do to improvement? Thanks!

Member Since	‎12-15-2010 08:19 PM
Date Last Visited	‎10-25-2017 11:45 PM
Posts	89
Total Helpful Votes Received	5

User Statistics

User Activity

How to label the traffic log which hit access-list?

ASA Etherchannel LACP hash algorithm type

PBR switch internal routing

Cisco 2960 MSTP config

Negative connection value meaning?

Re: How to label the traffic log which hit access-list?

Hello,

Thanks. I also find some

Hi,

Hello,