Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can i get an explanation for the below message "flush request sent".
28) Event:(null), length:159, at 352708 usecs after Thu Dec 11 02:31:06 2014
stp_flush_vlans_multi_port(2671): # of flush requests sent: (a) this batch: 1, (b) total: 3515; # of po...
Hi,
It is expected behaviour, when you remove the VLAN from L2 database with "No Vlan xx" command and you have SVI interface for the same VLAN will remain in running config. You need to remove manually using below command. Also you can see the output...
Hi,
You can run any dynamic routing protocol between VLAN 10 SVI and MPLS router to advertise VLAN 11 subnet.
Or you can do the static or dynamic NAT or NAT-PAT to convert the source IP address
Hi,
May i know where the router is connected to. Do you have access to that device.
Also we need to the router interface ip address which is connecting to internet.
Hi,
By default, all cisco catalyst enabled with STP. When you connect 2 or more switches in loop. It will automatically detect the loop and will take one port to blocking state.
If you are seeing the loop. Then please share us the "show spanning-tr...
Hi,
Could you please check "show ip int brief". I believe your protocol should be "down" since you configured two different subnet ip address for directly connected interface.
