Hello,
I have created a access-list rules which using to bypass VPN-like traffic to SFR.
And I would like to do summaries of them at syslog. Could you please advise how can I process it?
There are various of access-list group and I just want ...
Hello,
I would like to like what is the LACP hash algorithm type support at ASA? I am looking for Layer 3 + 4
Also, is it have paramters to setup rate fast feature, miimon etc?
Currently my ASA running version is 9.6(2)
Thanks in advance
Hello,
I am studying PBR now. With example like http://www.cisco.com/c/en/us/support/docs/security/web-security-appliance/118156-configure-wsa-00.htmlcopy and rewrite part of config---------- vlan ip address ------------interface Vlan10desc User VLA...
Hello,
Currently I am working on MSTP config. While check existing config it looks like my active VLAN is running under instance 1 (MST01).
However, my peer switch is running instance 0.
Q. First question is does it I should change back to inst...
Hello,
Could you please advise what is meaning of negative current connection value when run 'show service-policy'
Like below
----
Class-map: Incoming Set connection policy: per-client-max 2000 current embryonic conns 1801, current conn...
Hello,
Only I have following part:
==============================
logging enablelogging timestamplogging trap warningslogging asdm informationallogging host management 192.168.0.211logging class auth trap informationalno logging message 106015no lo...
Hello,
The switch itself can be as a L3 switch.
And I think need enable "ip routing" as well?
so what should be correct config for PBR?
----------------------------------------------------------
!
ip routing
!
interface Vlan10ip address 10.1.1.1 2...
Hello,
I saw the max incoming traffic is around 29,000 pkts/sec which I think is reach to limit of 30,000 by spec show.
However, is it CPU really high impact when over or near to limit it can handle?
Anything I can do to improvement?
Thanks!