I just installed a 886 router. I noticed that the xDSL CD light is flashing... slow then fast. I am assuming the DSL line is not syncing up. How do I go about diagnosing the problem. I am connecting to an ATT dsl equipment.
sh dsl int atm 0ATM0Alcatel 20190 chipset informationLine has not yet been activated.Modem Status: Down (DMTDSL_DO_OPEN)DSL Mode: UnknownInterrupts: 976203 (0 spurious)PHY Access Err: 0Activations: 0LED Status: OFFLED On Time...
Yes, I will get that for you.I think I purchased the wrong routers. I called Cisco pre sales and they said this was the router I needed. Does this router only support ADSL over ISND? I think I have ADSL2 over POTS.
The phone line RJ11 connector. I am assuming that the ATM 0 interface is using the RJ11 connector in the back of the unit. I also just noticed that the label says ADSLoISDN. I am assuming that this will work with SBC DSLline.
