Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a customer who is using three bonded T1 circuits on a 1721 router. He recently purchased a fourth line with the intention of adding it to his bundle. I attempted to replace his current 1721 router, which contains one WIC-1DSU-T1 card and on...
I have a customer with a Pix506E who would like to establish remote access VPNs to this firewall. Then after he's connected with the VPN, he would like to go back out to the internet from the pix to access a few of his webservers. The goal here is ...
I recently removed a blade of 48 fast ethernet ports from a 6509 switch running IOS 12.1(23)E1. I thought this would remove these ports from the running configuration, but it hasn't. When I do a show modules I see slot 5 as empty. But I can still ...
I have a pix 501 configured with static nats similiar to this:static (inside,outside) 123.123.123.1 192.168.123.1static (inside,outside) 123.123.123.2 192.168.123.2These two servers are mail servers. If one mail server needs to send mail to the othe...
RickThe interesting thing about the dysfunctional cards is that when I tested them in a lab environment they appeared to work properly. The closest that I could get to production conditions was to put the 2800 back-to-back with a 1721 and verify tha...
Rick, Thanks for all of your help. In the end it turned out to be an issue with the WICs that I was using. After accepting that the configuration was not the issue, I moved on to the hardware itself. Once I replaced the VWIC-2MFT-T1 cards that I w...
RickSorry for the confusion, I changed my troubleshooting strategy. Instead of trying to work with all four lines at once, I decided that I should try getting one line to work and build off of that success.Yesterday I did some testing with the avail...
I tried testing the line using the single available circuit while running "debug ppp negotiation." The following is the logged debugging result:*Mar 31 21:28:53.383: %CONTROLLER-5-UPDOWN: Controller T1 0/1/1, changed state to up*Mar 31 21:28:55.383:...
Here is a copy of the configuration from the 2821 that I am attempting to use. It may also be important to note that the other side of the connection is a 7206VXR (NPE 300).Current configuration : 1791 bytes!version 12.4service timestamps debug date...
