Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to decide on few things regarding this switch before recommending this switch to my customer. I have the following questions that i need some expert advice.Questions1.) Does this switch support POE 15.4W on all 48 10/100 ports (ESW-520-48P-K9)...
Need help to clarify this technical requirement. we are in the midst of designing a wireless Mesh AP solution for our customer.Customer Requirement:-1. Customer wants to deploy REmote MEsh APs (1500 Series) with a centralized 4404 Controller at HQ si...
Hi All.I need help in finding if a controller based LAP AP can be schedule shutdow or restart. This is a requirement from a customer and i'm not sure whether this can be achieved.Another question is, can we send the scheduled Guest ID and PASSWORD th...
Issue: Tried to configure WIC-1B-S/T-V3 on Cisco 2621XM but ISDN connection couldn't be established. Show ISDN status shows "Layer 1 not active". But whenever a WIC-1B-S/T card is used the ISDN connection was sucessful. Cisco document saysthe WIC-1B-...
Thanks fo the input leolaohoo however i have questions related to the below responce.1. If you have PoE switch, then you can enable EnergyWise where you can turn off power to each switchport; and finally- Can we do this based on schedule? to be disa...
With the current IOS running on the router, the card is detected but only the ISDN connection could not be established(Layer 1 DeACTIVATED). However as suggested i will try to upgrade the IOS version and test.Thanks.
