Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Ubiquity Pico Station M2 in bridge mode basically acting as a wireless card to the device that is connected to it with a patch cable. Both the Pico Station and the device connected to it are set for DHCP. In one building I have some old stan...
Hello, I've setup a ASA5505 with basic license running version 8.2 using all 3 interfaces, outside, inside, and the dmz. All is working as it should with the inside and dmz interfaces being able to access the outside and get to the internet.The issue...
We are looking to upupgrade from our standalone 1130 series AP's to a Cisco 2504 wireless lan controller and the Cisco LWAPP 2600 series AP's. Currently we have the 1130 AP's connected to a 10/100 3560 POE switch. We also have a 2960 10\100\1000 non-...
Kind of a silly question but I can't get the right wording from data sheets. Do you have the ability to setup DHCP servers on this layer 3 switch? I know I can with my old 3550 switch. Want to upgrade and make sure this model supports setting up dhcp...
I have a 48 port 2960 switch with 2 10/100 ports ( fa0/46-47) setup in an etherchannel with a 2950 48 port switch. I am getting total output drops on port fa0/47.Below is some show commands, anyone have any idea's why this would be?FastEthernet0/47 i...
FYI for others who may run into this problem.
The solution that worked for me was to turn on passive client under wlans\your wireless SSID\advance. This allowed my device behind the wireless bridge to get a DHCP address.
I was under the impression that the "no forward interface vlan1" on the DMZ interface was so the DMZ could not initiate communication to the inside network. I'm trying to have the inside interface initiate the communication to the DMZ network, which ...
