Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Morning, the config is as follows: ( more or less )http://www.hh.se/download/18.70cf2e49129168da015800092887/1234881384870/3_5_CME_Network_Parameters.pdfchanges to the doc in the link are noted here.Console(config)#interface FastEthernet0/1Console(co...
Hi all im stuck and would appreciate your help on this please. I recently moved and finally got around to setting up my routers a 857 used as a dum modem and my voice 1751 used for everything else.i had it setup in my other place everything was worki...
Hi Got a question regarding this wic-4esw card the router knows it's there from show inventory and the Ethernet interfaces are showing up, but I'm not getting devices to connect that is the pc plugged into the Ethernet on the switch card are not gett...
Hi I am having the same exact problem as this person had http://forums.whirlpool.net.au/archive/1509242I tried what was suggested but it did not help, when calling from an exterior line and the call is coming from my sip provider the exchange server ...
Hi allI've been searching for a way to have the router check the status of the dialed and if it's not responding and or down to have a TCL scrip reset the interface.Is this possible?Sent from Cisco Technical Support iPad App
Hi Alex,Thanks I'll give that a shot but I never created a sub interface fa0/0.1Data vlan is 1 as is the native vlan. I'll split them up to int fa0/0, fa0/0.1 and fa0/0.10 and apply the access list to fa0/0.1 and let you know how it goes.ThanksSent f...
Thanks for your answer Jeff yes you can do this in cme as well but I am using the phone as a switch port for the pcs so can really do this.Ideas welcomedSent from Cisco Technical Support iPad App
HiGood point, but no not a single one.Extended IP access list block-data-to-voice 10 deny ip 172.16.1.0 0.0.0.255 10.10.10.0 0.0.0.255 20 permit ip any any The 10 Network are the phonesinterface FastEthernet0/0 description $FW_INSIDE$ no ip add...
