Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So I need any ideas on best way to achieve this, i can think of a few but don't know which will be best. here goesI have a local network of 10.9.0.0/20 and need to create a bidirectional IPSec tunnel to a client site, they want me to present to them ...
We have a cisco 3560x-24-p with a C3KX-NM-10G module, we are trying to connect the Cisco switch to a Mellanox SX1012 switch using a Mellanoxx MC2309130-002-V-A2 cable however the switch doesn't recognise the sfp+ on the cable. We have updated to 15.0...
Our main internet router has two firewall's at our site, one of the asa's is ours the other is a client asa, the client asa has a ipsec tunnel and a riverbed steelhead caching device that goes back to there site in the usa. this is then used by the c...
thanks for your reply when trying this on the ASA i get invalid input as below ASA5510-02(config)# ip nat pool NAT-POOL 172.16.17.1 172.16.17.254 netmask /24 ^ERROR: % Invalid input detected at '^' marker.
so the issue is that i have to send the IP from site 1 to site 2 as 172.16.17.0/24 over the ipsec. i have no access to site 2 or any of it's equipment (it is at a client) from what i know i could do it using SVTI but wouldnt the other site (site 2) n...
