Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Team,I would like to find out following is possible for ISE posture with non-compatible switch like 2950:Setup:ISE 2.3Non-compatible switch Cisco 2950Goal:Achieve posture checking on endpointSuggest Solution:Implement AnyConnect on Endpoint for 802.1...
Please help to comment on followings: When ISE1 is disconnected from the network, ISE2 is responsible for the authentication; however, it is noticed that authentication log sessions in “Radius LiveLogs” are not synchronized back to ISE1 when ISE1 reg...
Hi, Anyone has any experience with Microsoft SCOM monitoring Cisco UCS? I want to tfind out if all UCS alerts from chassis, fabric interconnect etc. can be forwarded to SCOM.Rdgs,Leslie
Thanks Craig for the info. I am not familiar with SNMP CoA and as you've mentioned that 2950 does not support SNMP CoA, but is it possible to use SNMP to shut and no shut or to debounce the switch port if connected device does not meet the posture co...
George, thanks for the swift response. 1. Yes, only two nodes are configured. I am not sure the normal environment that you've mentioned. Is that more two ISE nodes or MNT must be on separte nodes? 2. will open case to followup3. It's a wired envi...
