Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Fellows,I have the following working scenario:I am using ACE Module for Server Load Balancing in 6500. I have configured it in Routed mode.I have configured a VIP which works well from Client and Server Side. Whenever a Client sends traffic to V...
Dear fellows,I have the following enviroment:2 6500 Core Switch2 ACE10-6500-K9 installed in 2 Core Switch3 context > AE,CE,PE6 SERVERS -> 2 servers for AE Context, 2 Server for CE Context, 2 Servers for PE ContextDefault Round Robin Load Balancing fo...
I have the following setup:Call Manager 5.1H323 Gateway with SIP Trunk to Call ManagerI am setting up following scenario:Connected new analog Telephone Line on H323 FXO portsetup connection plar for CUCM Extension on that FXO portI am not able to cal...
Dear Fellows,I have the following enviroment:2 6500 Core Switch2 ACE10-6500-K9 installed in 2 Core Switch3 context > AE,CE,PE6 SERVERS -> 2 servers for AE Context, 2 Server for CE Context, 2 Servers for PE ContextDefault Round Robin Load Balancing fo...
Dear IPT Fellows,We recently got a SIP trunk which is connected to our H323 Gateway. H323 Gateway routes all calls to our Call Manager.Inbound and outbound calls are working fine. Inbound DTMF is also working fine but outbound DTMF to SIP trunk is no...
Dear Jbartoldus,I tried according to your suggestion but no luck.Let me be more clear, From the Server Side, if a Server sends traffic to VIP, it should get the response with VIP as source address. Please let know if there are any other possible sol...
Dear Borys,I tried your first proposed solution and i am able to ping 172.20.0.45 from AE Context Servers. But i want the following scenario:From AE Context/Rservers, i should be able to reach 172.20.0.47(CE_VIP), 172.20.0.56(PE_VIP)Similarly, Each C...
Hi Borys,Thanks for offering help.Yes, i want to access all VIPs of all context from Server Vlan 130.With reference to point 1, If i configure same policy on Server Side, do i need configure VIP address as well?Can you confirm if this configuration ...
Dear gbljoba,Good hint bro and let me complete the Answer.In CUCM, i just enabled "Enabled Outbound FastStart" for "g711 ulaw 64-k" and Outbound DTMF started to work.Thanks for your support.regards,Rameez
Dear mrmhar,I have already modified and used the mentioned command under the dial peer 1012:dial-peer voice 1012 voip description ***Toll Freee*** destination-pattern 8......... voice-class sip dtmf-relay force rtp-nte session protocol sipv2 session...
