Dear Friends, Could you please help me out to configure the QOS on Inbound Traffic on a Cisco Router. Please go through the below commands and suggest if any changes required. ### To match the trafficip access-list extended ACL_2Mbpspermit ip 192.16...
Hey Guys,Please check my below configuration commands on asa 8.3>Question 1 : i want to send inside/dmz1/dmz3 internet traffic using firewall interface by PAT , please confirmif the following commands are correct?I. nat (any,outside) source dynamic ...
Dear All,I am facing Spanning Tree Loop when i connect the IBM Blade Centre switches to my Core1 & Core2 (6513) .Let me brief you the problem further as below .Current setup : we have two core-switches (6513) connecting each other with L2 ether-ch...
Dear Experts,Can you please verify my 6513 Core-switch Linecard throughput check as i am facing slow server performane issue.1) Are there any performance issues with 6513 module core-switch and i wanted to know i have a sup 720B in this core-switchw...
Dear Experts,I would like to share you my requirement as follows -Current setup :Core-switch : Lan protocol - Eigrp , Connected to Access-switches via trunk, Spanning Treee Root & VTP server.Layer 2 vlans, DHCP Scope Layer 3 vlans configured w...
Dear Doherty,Thanks for your reply!Objective : I want to dedicated 4Mbps bandwidth out of 8 Mbps on the ACL100 for the inbound traffic for these servers. 192.168.1.75---HQ-WAN ---MPLS cloud --8 Mbps --BR WAN--- 10.135.101.010.1.222.221---HQ-WAN ---MP...
Hi,Yes , Eigrp adjacnecy forming between Dist and Core switches.However host at access-sw not able to ping core switch ip-addres Can you please above commment in detail ...and let me know whether the scenario will work or not?Appreciate your posts ...
HEllo,I would like to inform you that there are no issues with module 9 of 6513, I just took it as an example as i justtested the throughput on hosts connected to that module.Can you please explain your below comment as i coudnt understand "" It po...
Hi,I tried your recommendation and achieved some part of my requirement.My current setup: Core-switch :interface Vlan7description HQ_Users_VLAN2ip address 10.1.2.2 255.255.255.0no ip route-cache cefstandby 7 ip 10.1.2.1standby 7 priority 110standby 7...