Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Community,We have a cluster of ASA 5540 working in a primary/standby configuration. We are using source-Nat on this cluster to NAT some multicast streams received from the outside interface to an inside subnet.Unfortunately, we have an issue wh...
Hello community , Please have a look at the pdf attached here . I am seeing the following error poping up into the kber1308 and kber1309 , the two switches connected to my mpls routers . This design works in a primary / standby set up , the primary l...
Hello ,I am working for a well known provider and I am currently migrating one of my client from Frame-relay to Metro-ethernet link .I am actually looking for advices on what sort of mechanism to implement to detect a failure in the ME parth .As you ...
Hello community . I have a strange behavior and a simple proble . I configured the following static route ip route 10.84.22.0 255.255.254.0 10.84.23.254That I advertsied in eBGP :router bgp 65000 network 10.84.22.0 mask 255.255.254.0the IP next hop ...
Hello Peter . I could do but : - This is a live environment - I would also have to make sure the client switches are also moving away from current SPT config to new RSTP configCould you please tell me: - where I can find the latest configuration best...
I gave the HLD for BER but CPT and all the others location are physically connected in the same way . the vrrp config is there primary router: interface GigabitEthernet0/0.10 encapsulation dot1Q 10 ip address 10.25.128.118 255.255.255.240 vrrp 10 ip ...
