Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody,
Actually what I want is permit TCP outside traffic into a specific host in my network using 80 port.
Can it be like this?
access-list 101 permit tcp any host 10.0.x.x eq 80
ip nat inside source list 101 interface g8 overload
May...
Hello everyone,
I'm having some issues with my router. I'm trying to connect it to the internet, I can ping to google.com but on the other hand, when I connect a machine in interface G1, I don't have internet connectivity, I think the problem is in...
Hi all,
I created 2 vlans in my switch
Vlan10 192.168.1.1 Ports 1 to 12 (all untagged for this vlan) Ports 13 to 24 (excluded)
Vlan 20 192.168.99.1 Ports 13 to 24 (all untagged for this vlan) Ports 13 to 24 (excluded)
IPv4 Interface already configu...
This is the config of my router
interface GigabitEthernet0 no ip address!interface GigabitEthernet1 no ip address!interface GigabitEthernet2 no ip address!interface GigabitEthernet3 no ip address!interface GigabitEthernet4 no ip address!interface G...
Thanks for your feedback, I already tried this but doesn`t work and I waswondering if it is because I have already created an ACL to allow trafficin my network.Thanks again
Hi,Thanks for your feedback, I already tried this but doesn`t work and I waswondering if it is because I have already created an ACL to allow trafficin my network.Thanks again
