Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am new to UCS and trying to upgrade the firmware which are running a numbers of Vmware VMs..I need an advise on where to start first? I have 1x5108 and 2x 5108 AC2 on firmware version as shown belowAnd the three servers B models are:UCSB-B200-M...
Hi,I want to bridge the WAN0 (GigabitEthernet0/0/0) with 4 LAN ports (GigabitEthernet0/1/0-3) on my ISR1111-8P. How do I make this uplink/WAN0 to bridge with 4 other LAN ports so that all those connected devices LAN receive an IP via WAN0? ISR1111-8...
Hello Experts,My ISP is assigning only public IPs (up to 5 IPs) via DHCP as I cant get static from them. Now, I want to bridge the WAN0 (GigabitEthernet0/0/0) with 4 LAN ports (GigabitEthernet0/1/0-3) on my ISR1111-8P. Currently only WAN0 is UP and r...
My ISP allows me to have up to 5 public IPs and I would like to use one of them for LAN2 port.
Is it possible to bridge port2 on the RV340w router? If yes, could you please explain the steps, I could not find it in the guide and not really if it is...
thanks, Steven, all three chassis are managed via a single UCSM, now does it mean I can upgrade the UCS manager to the latest and then keep the BIOS version of M2 to what it is and only upgrade M4, and M5? what about the FI models? what would look l...
Enable Debug and logs and enable 5Ghz. Connect some cellphone and laptop and the minute it gets disconnected and stops working, then note the exact time, lets say the router stopped working at 11:35 am, then search logs in that time frame and look fo...
Salam,I got my RV340W issue fixed with Cisco TAC support.The solution was to replace the router and got a newer revision HW version03 (PID VID: RV340W-E-K9 V03). As I said in my first comment the issue seems to be related to hardware and not firmware...
Balaji, Thanks for trying to help. Are you familiar with IOS XE ISR router? The command, you provided is only working on the WAN interface but not LAN as the error clearly shows, it might be for ASR router. If you are familiar with XE ISR then you wo...
For WAN ports it worked but for LAN port I do get an error when I run those.ISR1100(config)#interface GigabitEthernet0/1/0ISR1100(config-if)#no ip addressISR1100(config-if)#negotiation autoHalf-duplex or Full-duplex (sub)command not supported for Gig...
