Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to apply a policy-based route on one of our L3 switches (Cisco 3750) to change the next-hop of a couple of servers only. The VLAN where those servers reside got WCCP enabled on it. When I want to apply the route-policy to that VLAN inter...
We would like to enable ACS authentication to login to different routers (Cisco 881s) we got that are interconnecting with our WAN via VPN tunnels. We would like to avoid using public IP for the router to communicate and relay user/password info w...
We would like to enable ACS authentication to login to different routers (Cisco 881s) we got that are interconnecting with our WAN via VPN tunnels. We would like to avoid using public IP for the router to communicate and relay user/password info with...
Perfect! this is the command i've been looking for. I also found the same for TFTP but not syslog though. any clue how to force the source address for syslog?I just tested it with TFTP and it worked great.Thanks Richard!
i'll be testing this with TACACS this week but i am wondering if we can do the same with SYSLOG and TFTP where the router can use its LAN private IP as a source IP to send data via SYSLOG and TFTP thru the VPN tunnel.Thanks,
