Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am setting up NEW T1 Connection. Getting Line Protocol Down.Already tired replacing the cable, and replacing another router. Using Cisco 1721.Also, tried loopback on WIC Card - Line protocol is down even when I put in loopback meaning problem is th...
This is your default route. You can also use ASDM and check mark (in WAN connection) to obtain default route and apply the config. You can also use outside interface instead of ip address.
Yes, You will run into this problem due to CDP.Easier way to fix this is to Turn off CDP in ESW 500.Go into Cisco ESW 500 (While SPA Phone is not connected)On the left side:Monitor & Device PropertiesSNMP and Than CDPYou will notice CDP (Cisco Disco...
card type is showing up as invalid command on this router.I am using 1721. Also tried it on 1841. On Both router(config)#card type ? is not showing any info - Saying unrecognized command. And Yes I did do this in config mode.
Looks like you have no routes at all.You can eithe manually enter the routes likeip route a.b.c.d 255.255.255.0 x.y.z.h 255.255.255.0or you can use any routing protocollike Rip v2 or EigrpFor example, if you have 192.168.3.0/24 conneted with router;...
