Hi, I have 2 Nexus C3164Q-40GE switches and currently there is a trunk connection between the 2 switches. I want to have VxLAN config so that it can pass between the 2 NX switches. I read many articles but can't really have an idea how to config VxLA...
We have a lot of users connecting to the access layer switches, and some users cause to make broadcast issue. I heard that storm control works only inbound? So I want to know where to configure the storm control. Please see attached. Red? (Access lay...
Hi,
I recently upgraded the firewall hardware that was connected to a switch.
After upgrading the firewall (IPs are the same), I couldn't ping from the inside interface on the firewall to the switch.
I couldn't also ping from the switch to the in...
I had an issue migrating from the single 5540 firewall to the context 5585 firewall.
The configs are the same. The only differences are software version (old one 9.1 and new firewall is 9.7) and the new firewall is a multi-context.. This firewall is ...
Thanks for your reply!
The issue was resolved by rebooting the firewall.. I know it's funny.
After reloading the firewall, eigrp came up.
I'm not sure why.. I don't know it is because I changed the allocate interface?
With the switching of alloca...
Thanks for your reply again.
One more question.
So the switch with the code can support the following ?
encryption aes-cbc-256 integrity sha256 group 14
Thank you so much for your reply!
No. This is not for GNS3.
Just double checking with you :)
This is the sh ver output of the router. Can you double check if IKEv2 still supports?
7206#sh ver
Cisco IOS Software, 7200 Software (C7200P-ADVENT...
Hi,
The both routers are connecting our data centers.
10.17.x.x
10.19.x.x
Those network above are the networks of our data centers.
Eigrp 1 is for routes being advertised from their end and also for communicating with our data centers.
Eigrp ...