Hossam,
Do you have a Console access to your device ? if not than you need too. It seems like you did otherwise you'll not going to be able to grab all that output.
It seems all normal to me try not to touch your keyboard for a good 10 or 15 minute d...
Ryan,
I had to upgrade as well or dealing with that process just recently. The steps you listed above are the Cisco recommended steps but for some reason it didn't work for me.
We upgraded from 5.3.x to 6.2.x. promote / démodé one CM from Prim to St...
Trey,
I've noticed the same issue/alarms as well. my case was a new deployment. I would suggest the following.
- Make sure your physical layer all in check with your design.
Make sure interface are match to your configuration for the WCCP
- Check y...
