Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am attempting to setup internet redundancy at one of our sites but can't figure out a solution for an issue we are facing with non meraki VPN failover. On the MX....WAN 1 = Local InternetWAN2 = Existing MPLS connection (Internet egress on east coas...
The issue with entering the location ID is that when the tunnel fails over to WAN1 the non meraki tunnel will not come up because WAN1 is local internet and is using a different public IP. Therefore it breaks all internet traffic when using WAN1 when...
I have the same issue with 8.2.166 version of code. I did try turning POE off on the ports but the controller still crashes when plugging into the POE ports (3 & 4)
