Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
FiberSomething is not right. The 'sh run' shows interface g1/48 as 'shutdown', but the 'sh int g1/48' shows it up/up.Can you verify that it isn't shutdown.
Hi MannyIt appears that the mtu size command is in reference to egress traffic on a FastEthernet port.See the config guide for 12.2(SXH)Configuring a nondefault MTU size on a 10, 10/100, or 100 Mbps Ethernet port limits ingress packets to the global...
Hi DaveYou can issue the 'switch read switch_num' from enable mode to find out the switch ID. If you have already converted over to a VSS configuration and need to change the switch ID's, you can use the following command:#switch set switch_num 1HT...
