Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i installed Virtual MSE by beplying ova file, and after typed the default username and password and completed the installation process. it stuck as shown in the attached snapshotdoes any one have any idea about this ?
Hello,i have two 7911G ip phone, both of them can't resolve ip from DHCP service on 2651XM Router have CME 4.0the phone stuck in "configuring ip" statethe strange thing !the same phones can easy get ip and register on Dynamips "Router Emulation progr...
now to avoid my trick about Dynamips and let it offical i just applied the DHCP configuration on Dynamips without telephoney-service and let the default router is 2651XMand the phone can easy get ip from DHCP, then register on 2651xmbut it's not log...
thanks Niranjan and Michael for your interesti already configured the option 150 ip address with CME ip address in the first time and the same result i got, then i let my PC acting as TFTP server, because changed many SCCP firmware, as i thought it's...
i have the same issue except i didn't try with non-cisco gatewaymy CME is behind NAT and i need to register x-lite on it from outside network, i have no problem when i tried to register from inside here is my config[code]voice service voip allow-conn...
