Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have a number of Cisco 9200 switches to build and would normally build these manually ( old school ). Decided to be all modern on this one and try to automate the build process for the Cisco 9200 switches. Big mistake !
There are a number ...
Hello,Hopefully someone may have experience with this.We have a number of Cisco SG300 switches to build and have been looking into using the auto install process to automatically update firmware and perhaps install some template configuration.After l...
Forgive me if this question has been asked in other forms before but I have not been able to find a recent answer.Does the Cisco ASA platform support /31 RFC 3021 addressing on it's interfaces in any of the latest versions of code. We work regularil...
Hello,I have a quick question before I log a TAC case on this with Cisco.We have a Core 6500 in a VSS configuration running Sup2T with 15.0sy code. We also have some Nexus 5596 in L2 only running 5.2 Code. We are playing with Microsoft NLB and I am...
Hi,Just a quick question to see if anyone has this working as I an not sure if it is even possible.At present I have a WLC5508 as a guest anchor in a DMZ and a web-auth passthrough WLAN configured. There is a custom web bundle providing a terms and ...
I was on some Cisco Partner training last week and asked the question there. The verbal answer was the 9200 does not have enough flash memory to complete ZTP firmware upgrade in install mode, with guestshell enabled. They have put me in touch with ...
You could try to upgrade to 8.2.166 or the latest interim 8.2 MR7.These are the TAC recommended builds. There have been many bugs with AP COS APs.
Regards,
Robert
I have just been struggling with a similar issue on a fresh install of Prime 2.1 Upgraded to 2.1.1. If I try to create the user with lobby ambassador role it just fails with "unexpected internal error". I eventually found that by creating the user a...
