Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Experts,I need to build a back-up MPLS connectivity for an existing MPLS link connecting multiple locations to DC and DR as shown in the diagram.ISP-1: Existing linkISP-2 New connectivity. In ISP-1 CPE to PE Routing is static and for some reason...
Dear All,
I am planning to configure IPsec Tunnel over MPLS connectivity from the service provider.
IPsec tunnel is configured between WAN interfaces of the CPE's at all locations.
As per my understanding IPSec encrypts all traffic going inside th...
Dear all,I have a customer with 10 locations connected to their hub location via MPLS from two different ISP's ISP1- Primary MPLS ISP2-Secondary MPLSat 5 locations including hub they are running BGP with MPLS.(No problem here)in remaining 5 locations...
Dear All,I have a requirement where 3 Branch locations of an organization is connected to their hub location via MPLS.They have an internet connection only at HUB as shown in the diagram (Attached)Now all spoke locations should access internet via hu...
Dear All,I have a requirement where 3 Branch locations of an organization is connected to their hub location via MPLS.They have an internet connection only at HUB as shown in the diagram (Attached)Now all spoke locations should access internet via hu...
Thanks Vasilii,In case of DC and DR Scenario should I create two tunnels from each spoke on each ISP?2 tunnel to DC from 2 different ISP+ 2 tunnels to DR from 2 different ISP from all locations?
Dear all,I am sorry to say this, RPS-2300 is not a great product from Cisco. I have faced lot of issues after ordering this product..There is no clear ordering guide or nor the SE's of Cisco aware about this product..Avoid RPS-2300 as much as possib...
No no its one VRF, 3 different offices of same organization. I want to know a way in which VLAN1 (office-1) traffic goes via link-1(512kbps) to MPLS cloud VLAN2(office-2) traffic goes via link-2(1Mbps) to MPLS cloudVLAN3 (office-3) traffic goes via...
