Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need some help with ether-channel configuration between my two switches. I tried to set it up, but i guess i didn't have the correct configuration because it did not work. What would be the proper configuration to connect a 2960x and a 3850 stac...
Firtsly, thanks for reading and putting up with my basic questions. I have two new Catalyst 3850 switches that i am installing in a stack as my new Core Switch. I have the switches wired up and stacked and the proper master picked and all switches l...
I am looking for some help on how to properly configure/create a new stack using two WS-C3850-48T-S switches. These are two brand new switches directly out of the box and never been powered on/configured. What is the proper procedure to configure th...
I have an ASA that is supporting my guest internet access. It is supposed to be separated as much as possible. Right now, i have a VLAN (named 200) setup on my switches with no SVI, so traffic cannot escape that vlan. On my ASA, one interface is ...
I have an ASA 5505 with a base license currently running in my office. It serves as the firewall and router for my guest wireless network that has a dedicated internet connection that does not touch the corporate lan. Currently there is an Inside int...
I was able to figure it out.... I had a mismatched configuration between the port-channel and the interface on the 3850 causing the port to go into a suspend state. I made sure that the configuration between the two matched and then shut/no shut the...
yes i missed the portfast statement, which i knew i needed to remove since it was an access port before..... Yes i am going to two different stack members (so if one fails the communication to the access switch stays up). How do i force LACP?
Here is the relevant config for each of the switches that i had and didnt work.2960Xinterface Port-channel1 description CHANNEL TO US20SWI254 switchport mode trunk switchport nonegotiateinterface GigabitEthernet1/0/47 description CONNECTION TO US20SW...
Ok great. Thanks for the response. Since there are two switches in the stack and this will be my "core" responsible for the VLAN configuration as well as routing, how many IP addresses will be needed? Only one for the stack or will one be needed for ...
