Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm attempting to setup a CVR-X2-SFP V02 TwinGig converter module on it. I can't execute the commands recomended on the setup guide to change the mode to Gigabite mode. The command hw-module uplink select all fails because the uplink option is not av...
I'm setting up a new 4900m running cat4500e-ipbase-mz.122-53.SG5.bin. I'm attempting to create Port-Channels as a Trunk for uplink to a 4503 running cat4500-ipbase-mz.122-37.SG1.bin. When I attempt the command "switchport trunk encapsulation dot1q" ...
I have a couple of Supervisor Engine 2 that I need to upgrade memory in order to run the latest IOS and to set them up as redundant SUPs on a 6513. I run in to the following simptoms on both Sups so I figure there must be something I'm missing. Both ...
I am troubleshooting a 6500 router wih a SUPII.The Flash card with the IOS is not accessible to the router (can't read from it possiblydamaged) and it's on a contious boot loop. I've try to access the ROMMON consolobut the break sequence simply doesn...
Hi; We have a 6513 equiped with a WS-X6K-SUP2-2GE a WS-F6K-PFC2 and a WS-F6K-MSFC2. The switch is running IOS Version 12.2(18)SXF1. I'm able to obtain netflow readings of traffing going across the different Vlans but nothing with in a Vlan. Here is t...
I did read the section of the document but it's not applicable because this is the only Module on the Switch. All other ports are empty. In regards to the bug, This section lists the resolved caveats in Release 12.2(50)SG3:• Workaround: None.Once the...
Thanks! You care corect. Cheached capabilities and it can only handle 802.1q. Port-channel2 Model: N/A Type: N/A Speed: N/A Duplex: half,full,auto Auto-MDIX: no Trunk ...
You are correct, that is the OID that should contain the User name, but when I querie it I get and OID unsupported response. Is there a problem with the IOS version? Or an I missing something else?
you are right route-cache is apply on the Vlan interface directlly, but the documentation indicates that in order to obtain Layer 2 flow with in a single Vlan we need to apply the IP flow layer 2 command and I can't do it. In the Global Config mode t...
Thanks for the tip.I've actually been able to apply the IP flow ingress/export layer2 command to the appropiate vlans. But the one I can't seem to apply is the ip route-cache flow. according tot he document this is the one generating the netflow info...
