Hi Christian,Yes you will have two inside NAT + one outside interfaces.Here's a Cisco NAT reference stating examples with more than one inside interface:http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e77.shtmlYou can u...
Hi Christan,Here's one possible solution:Configure I/Face 3 as "nat inside"!interface 3ip nat inside!Then for your 1 x private address device, use the "ip nat inside source" cmd in conjuction with an access list & nat pool to ONLY NAT traffic to the ...
Hi Traugott,The trick here is to preserve the "tag" {VLAN ID} across the ATM WAN. You will need to establish VLAN trunk connections between the switches and 7204 routers via either using ISL or 802.1q encapsulation. From what I have read, the "tag" i...