Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,is the applied schema a valid setup to terminate wholesaletraffic (double-tagged , STAG/CTAG) on the PE Router (which is also the endpoint for mpls transport) or is there a better solution ?Thanks for feedback
Hello,
i have tried to connect an
ASR1004(RP2,ESP20,SIP10) and a C6504E(VS-S720-10G)
over 10G direct links.
10G port on C6504E
is located on a
WS-X6708-10GE ( with WS-F6700-DFC3C)
linecard. Both interfaces are
MPLS enabled via mpls ip
IP connectivity...
Hello,
i have a setup where i need to route a Subnet to L2-Connected IP Subscriber.
It's a dhcp initiated Session with a fixed IP Address (host Reservation by OPT82 circuit-id)
I have put a static route on the ISG ( a.b.c.d/29 via Subscriber WAN-IP) ...
Hello,
Sorry for the late response - no there is no
VSS
configuration - all connections are
Point-2-Point links with /30 Subnet and IS-IS enabled
( no L2 aggregation)
hi all,
i restarted the module in slot 2 on
C6504E with hw-module module 4 reset
but nothing changed. so i decided to reboot the entire
C6504E
and now all is working.
C6504E#sh mpls ldp neighbor te2/1Peer LDP Ident: 172.16.217.254:0; Local LDP Ident...
i was on site today and did some extensive testing - i have nailed down the problem to the ports on the WS-6708-10GE Linecard in C6504E.
STEPS i have done
replaced all affected tranceiver and cables between
ASR1004 and C6504E
=> failure still exist...
I think the "original frame" from the ASR is smaller than the required minimum frame size of 64 byte so the ASR has to do padding. All other frames (LDP hello) are large enough and no padding is done. The (RST,ACK) packets from
C6504E
has a padding b...
