Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I'm trying to get the Last input never information via snmp regarding to each interface from my Cisco C9200L-48P-4G switches? The idea is create a discovery rule in the Zabbix to monitor the amount time that each interface in the switch i...
My case id # is 00150352 and the details are below:I Cannot complete the Networking Essentials course, offered via skill forall platform, the last chapter won't mark as complete. Same after I haveanswered every evaluation questions about to the cours...
I have two WS-C4500X-32 switches interconnected via 2x Pear 2 Pear connection with different ISPs.There are two paths setted with different Distance metrics. Therefore when I shutdown the interface with low metric, the routing table don't change aut...
I have two WS-C4500X-32 switches interconnected via 2x Pear 2 Pear connection with different ISPs.There are two paths setted with different Distance metrics. Therefore when I shutdown the interface with low metric, the routing table don't change aut...
Do someone know some vlan management software tool to set vlan via GUI without have to access the switch via CLI? I wiish give this task to some specific users from IT Team.
That's it folks,I found the logic for never use interfaces. They just compare the Uptime with the Last Input Never information that we get via snmp. If both are the same, so means that there interface in the switcher never was used.Now that I got the...
I did not find nothing until at the moment. Same the Data sheet of this equipment continue making references to this MIB "OLD-CISCO-INTERFACES-MIB" that is the same that I'm using.But I end up of see a stranger thing here... The returned time for the...
Hi @balaji.bandi ,Thank you for your answer. See...As I noticed before can get by SNMP the correct information related to the LAST INPUT informations of interfaces in use or not as you can see below.The main problem is that when one Interface that ne...