Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello team,I hope your are safe and doing well.I am facing a real connectivity problem with our ASA 5525-x after reimaging it to FTD version 6.6.4In fact, we can't ping the management interface and therefore impossible to join the device to FMC. NB: ...
HII have a strange issue on my Firepower Management Center virtual.As shown attached picture, our FMC running software version 6.4.0.10He has a normal internet connection configured, and is registered with it's smartnet contract.I can install produc...
Hello team,We face a problem. We have a Cisco 9000 series switch, specifically a 9200.It is used as an access switch. He is in production and works perfectly. however, the LEDs of the different ports do not blink.After restarting, the LEDs work for a...
Hi, I have a problem whith my linecard that stay in-reset mode. ASR9K Route Switch Processor with 440G/slot Fabric and 12GB Version 5.3.4 RP/0/RSP0/CPU0:ios#sh plat sum loc 0/1/CPU0Tue May 22 19:40:02.189 UTC-----------------------------------------...
Hi,In our infrastructure we have implemented VSS virtualization from two nexus 6500 switches.the VSS confection was well done.However, one of the etherchanel ports of the VSL gives discards error.The goal is to find out if it is possible to replace a...
okay. I would explain my problem differently.Suppose we have two CISCO 6500 Catalyst Switches.and its two devices have been configured in vss.During VSL link configuration, a 10gig port on each Switch was used.SW1 (config) #interface port-channel 1SW...
We want to take two new 10gig ports and build a new Etherchannel link.In fact, we had at the beginning of two ports 10gig (on each switch nexus) which allowed us to have a VSL of 20gig. unfortunately, a problem at a port led us to disable it. we left...
