Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The responses here are pretty solid. Something went amuck during my first time provisioning that I couldn't get the ATA 192 remotely signed in no matter what I did, so I had to start from scratch, and thus could't call out or receive any calls, but t...
You only need one of them configured on the switch were your core AV device is that discovers all the A/V devices on the network(and put the querier on the correct vlan). You also only need the IGMP querier if they are on separate switches. We had a ...
Unfortunately months passed and they promised it would be resolved in an update but I never found that to be the case and I let the support case slip away. They did acknowledge the issue but we had to go with no LACP aggregation since the QSYS core c...
Thanks so much for your detailed explanation. Helped me understand how to design our network for QSYS Audio/Video install. One problem I ran into that I couldn't figure out is that IGMP querier did not make it past an aggregated link between Merakis....
hey Nathan, Thomas, and husycisco, this is super helpful. I found myself in a situation where I need mutiple cisco ASAs at different sites to connect to a single Azure VNet.
How does one go about finding the INNER Tunnel BGP Peering IP?
I too have t...