Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have CME version 10.5, and combination of SIP & SCCP phones.
This is about remote presence using BLF speed dial.
- SIP phone (8851) on site A can view SCCP ephone dn on the same site -> OK
- The same SIP phone on site A can't view SCCP ephone ...
Hallo,
I have CME 10.5 with 2 PSTN lines.
There is combination of SIP & SCCP phones here. How if I want to route an outgoing call from a SIP phone to a voice port?
Thanks.
Hi dawsonpettifer1 & all,
I have the same issue.
This is the config I added, by tagging digits in the front of dialled number, but still doesn't work.
Do you know what's wrong?
Thanks.
dial−peer voice 1 voip translation−profile incoming Phone3 answ...
Please see below the related config on CME site A.
voice service voip ip address trusted list ipv4 118.82.32.132 ipv4 10.1.100.250 ipv4 10.2.2.253 ipv4 10.2.100.253 ---------------------------------------------> (CME on site B) allow-connections h323...
Hi Dennis,
Thanks for the information.
The 2 locations are connected using VPN (SIP trunk).
Given the fact that using BLF speed dial, SCCP phone (8945) on site A can view SCCP phone (8945) on site B, I think the SIP trunk has been configured correctl...
